Toshiba GR 200 Series, Инструкция по эксплуатации

Страница: 521 / 1563

6F2S1915 (0.46)
GRZ200 (Soft 031 & 032)
- 500 -
(ii)
Receiving “select command Off” from the remote-end
Figure 4.1-3 outlines the reception of the select command ‘Off’ from the remote- end.
Signal reception
IEC61850
Select command Off from remote-end
Signal output
Select
decision
Success
Failed
Selection logic
Select stage
Cancel logic
Wait for a next command
Cancel command
Wait for a command
Operate logic
Operate command
Cancel logic
Operate logic
Select command On from remote-end
Select command On from front panel
Select command Off from front panel
Select command On by the PLC
Select command Off by the PLC
Figure 4.1-3 Outline of select command ‘Off’
Input point required mapping
Figure 4.1-4 shows the select logic when a “Select command Off (Remote-OFF-Control)” signal
is received at the input-point “DEV01_CONTROL_REQ”.
“SPOS01_FSL_BO_CSF”
(510001 _ 8A01011DC4)
SPOS01 function (Function ID:
510001)
DEV01_CONTROL_REQ
Command
“Remote-Off-Control”
ILK
† condition (“Off”) passed
Either
“SBO mode” or “DIR mode”
(e.g.,
“ctlmodel” in IEC61850
*
)
In SBO operate
In DIR operate
Selection
“Failed”
510001 _ 7001016D08
SPOS01-Off
To BO connection
Input Output Selection logic in SPOS01
0.1s
0
t
0.6s
0 t
&
&
&
&
&
Selection
“success”
“Automatic sequence control function (AQEQ)
§
” in progress
ASEQ_MULTI_SEL
Select condition
‡
1
≥
Select command
with ILK
†
condition
Operate command
with ILK
†
condition
Select command
without ILK
†
condition
Operate command
without ILK
†
condition
For SBO operation
For DIR operation
To
“Wait for a command”
For DIR operation
For SBO operation
Figure 4.1-4 Select ‘OFF’ from the remote-end in SPOS01 ††
†Note: The ILK function provides the operation criteria for “Off”.
‡Note: The “select condition” signal is provided. See Figure 4.1-13.
††
Note: To identify the input and output points of the other SPOS logics, see Table 4.1-5
and Table 4.1-9.