19
Set the handset in the
test mode 3, check
whether deviation of the
TX data is app. 8 kHz
Dev.
Check whether there is
a 250 Hz data
waveform at C453.
OK
NG
Set the handset in the
test mode 6, 926.997467
MHz (250 Hz ±8 kHz
Dev.) 1mV output signal
from RF jack is applied.
Check whether the bell
ring.
OK
NG
Place the handset on the
base to charge about 5
seconds, then connect
again.
Check whether there is
a 250Hz data waveform
at the Q402 collector.
Check RT402, Q402 and
their peripheral circuits.
NG
Check IC404 and its
peripheral circuit.
OK
A
Check RT403, R441,
R442, R443, R444,
R445 and C453.
NG
Check handset RF unit.
OK
Check whether the 250
Hz data waveform from
pin 9 of IC401 is fed.
Check handset RF unit
and the peripheral
circuit of IC401.
NG
Check whether there is
a 250Hz data waveform
at pin 40 of IC404.
Check IC403 and its
peripheral circuit.
NG
OK
OK
Содержание FT-8509
