Toshiba e-studio281c, Руководство по обслуживанию, Страница: 132 / 414

e-STUDIO281c/351c/451c © 2005 - 2008 TOSHIBA TEC CORPORATION All rights reserved
CONTROL PANEL
5 - 6
45 Select the same size
insert2 sheets as the origi-
nals
Displayed when the size of insertion
sheet (sheet 2) is different from that
of other pages at Sheet Insertion
Mode
46 Set insert1 sheets in the
same direction as the origi-
nals
Displayed when the direction of
insertion sheet (sheet 1) is different
from that of other pages at Sheet
Insertion Mode
47 Set insert2 sheets in the
same direction as the origi-
nals
Displayed when the direction of
insertion sheet (sheet 2) is different
from that of other pages at Sheet
Insertion Mode
48 Set transparency film in A4/
LT direction
Displayed when the selected paper
size is other than A4/LT at OHP
mode
49 CHECK PAPER IN LARGE
CAPACITY FEEDER
Papers in LCF are set incorrectly
50 CANNOT PUNCH THIS
SIZE PAPER
Displayed when the selected paper
size is not specified for hole punching
51 Remove paper from the fin-
isher
Displayed when the paper sizes are
mixed at Staple Sorting Mode
52 Cannot staple this size Displayed when the paper size is not
specified for stapling at Staple Sort-
ing Mode
53 Remove paper from the
saddle stitch unit
Finisher is full of papers
54 Examine stapler Trouble in the stapler unit in finisher
55 Check staple cartridge No stapler in finisher section
56 Check staple cartridge in
the saddle stitch unit
No stapler in saddle stitch unit
57 Job interrupted job 1 saved Interrupt copying is accepted
58 Ready to resume job 1 Interrupt copying is cancelled
(finished)
59 Cannot use AMS mode Displayed when reproduction ratio is
set to be over 200% at AMS Mode on
RADF
Set the reproduction ratio 200% or
below manually
60 More than 200% is not
available
Displayed when reproduction ratio is
set manually to be over 200% on
RADF
Set the reproduction ratio 200% or
below
61 Updated the template set-
ting
Displayed when the template stored
is recalled by pressing [TEMPLATE]
button
62 Enter Department Code Displayed when a button is pressed
while the department management
setting is available
63 Cannot copy BLACK mode
Check DEPARTMENT
COUNTER
Displayed when the number of print-
outs exceeds the limit number of
department counter
64 Cannot copy FULL COLOR
mode
Check DEPARTMENT
COUNTER
Displayed when the number of print-
outs exceeds the limit number of
department counter
65 Cannot copy TWIN COLOR
mode
Check DEPARTMENT
COUNTER
Displayed when the number of print-
outs exceeds the limit number of
department counter
No. Message State of equipment Note