Toshiba E-STUDIO 2020AC, Руководство по устранению неисправностей

Страница: 97 / 104

When Printed Sheets Overflow from the Exit Tray 97
TROUBLESHOOTING FOR
THE HA
RDWA
RE
0.
When Printed Sheets Overflow from the Exit Tray
When thin, small size paper (A4-R/LT-R or smaller) is used, the end of the sheets may get stuck in the exit tray walls. If
300 or more sheets are printed under such condition, some printed sheets may be pushed out of the exit tray.
In the case above, installing the paper exit stopper at the designated location of the exit tray will increase the amount
of recommended plain paper that can be loaded on to the exit tray to about 500 sheets.

When printing a large number of large size sheets such as A3 and A4/LD and LG, place the paper exit stopper back in
its original location.

When the finisher is installed in the equipment, use the paper exit stopper installed in its original location.

When the Job Separator is installed in the equipment, attach the paper exit stopper at the designated location of
the exit tray.

When a large number of large size sheets such as A3 are output to the exit tray of the equipment while the finisher is
installed, remove them in more than one time.
Removing the paper exit stopper from its original location
1
Unfold the paper exit stopper located on the left of the exit tray and remove it from its groove
while pushing the fulcrum inward.
Installing the paper exit stopper in the designated location for improving paper exit
1
Turn the tip of the paper exit stopper to the left and insert the paper exit stopper fulcrum into the
groove on the exit tray.
Placing the paper exit stopper back in its original location
1
Remove the paper exit stopper from the groove on the exit tray while pushing its fulcrum inward.
2
Install the paper exit stopper in the groove on the left of the exit tray.