8
Before you ask for maintenance, please check according to the table below.
Problems
encountered
Reasons
Solutions
Purifier cannot run
The effect is bad to
eliminate smoke and
odor
Filter cleaning light does
not extinguish
It is hard to eliminate the
odor and smoke
- It is possible that the power cord is not plugged
or poor contact with power cord
- May not turn on the power switch
- It is possible that the filter is not installed in
place and safety switch is not triggered
- Please connect power and make good
contact
- Please turn on the power switch
- Please properly install the filter and buckle
the back cover
- Please properly install the filter assembly
- Please replace the new filter assembly
- Please remove foreign matter from the air
inlet
- After cleaning the filter assembly, long press
the "UV" button for 3 seconds
- Please remove the packaging bag outside
the filter assembly
- It is possible that the filter assembly is not installed well
- It is possible that the filter assembly has reached the
end of life
- It is possible that the air inlet is blocked by foreign
matter
- It may be that the "UV" button is not long pressed for
3 seconds after the filter assembly is replaced.
- It may be that the filter assembly is also wrapped in a
packaging bag
Please send it to repair in case of the following:
1. If the operation is abnormal or the machine does
not operate, and the above method is invalid;
2. Substances or water from the outside have
entered and abnormal operation has occurred.
FAULT SELF-DETECTION
