1
TOSHIBA Thermal Printer
B-852 Series
SUPPLY LOADING INSTRUCTIONS
This sheet contains only the media and ribbon loading procedures. Please be sure to read the Owner’s Manual in
the CD-ROM for further information about this printer.
1. LOADING THE MEDIA
1.1 Assembling the Supply Holder Frame
1.
Assemble the Supply Holder Frame (L) and Supply Holder Frame (R) to the Supply Holder Base using the
two M-4X6 Wing Bolts supplied, as shown below.
1. Do not touch any moving parts. To reduce the risk of fingers, jewellery, clothing, etc., being drawn into the
moving parts, be sure to load the media once the printer has stopped moving completely.
2. The Print Head becomes hot immediately after printing. Allow it to cool before loading the media.
3. Care must be taken not to pinch your fingers when opening or closing the Top Cover.
4. Be careful not to pinch your fingers by the Supply Holder Frame or Media Holders when loading the media.
AVERTISSEMENT!
1. Ne touchez pas aux éléments en mouvement. Pour éviter les risques que les doigts, les bijoux les
habits, etc. soient tirés vers les éléments en mouvement, rassurez-vous de charger le média lorsque
l'imprimante est arrêtée complètement.
2. La tête chauffe beaucoup en imprimant. Laissez-la refroidir avant de charger le média.
3 .Prenez garde à ne pas vous pincer les doigts lorsque vous manipulez la capot supérieur ou le capot
coté droit.
4. Prenez garde à ne pas vous pincer les doigts lorsque vous manipulez le cadre support média ou les
guides lors du chargement média.
WARNING!
Supply Holder Base
Supply Holder Frame (L)
Supply Holder Frame (R)
Wing Bolt
NOTE
:
Make sure that the two small flanges at each end of the Supply Holder Base fit into the small rectangular holes at the
bottom of the Supply Holder Frames before tightening the Wing Bolts.
!
0 0 T S C C 0 1 5 6 6 0 3 !
