Toshiba AW-9500SBJ/SBK/SBX, Руководство по обслуживанию

Страница: 20 / 52

– 19 –
Check Point
(5) Whether the drain hose is connected to the drain pipe
tightly. (Whether it is warning alarm condition.)
(6) Whether the drain hose collapses.
(Whether it is warning alarm condition.)
(7) Whether the drain hose is blocked.
(Whether it is warning alarm condition.)
Note:
Keep the gap between the top of the rubber pipe and the
washer pan.
At washing and rinsing process, reverse rotation is performed
to loosen fixed clothes for the last 20 sec.
(1) Whether automatic correction mode for uneven loading is
performed during operation.
(As the procedure (water supplying-stirring <1 min.> -
drainning) is automatically performed, if the fixed clothes
are loaded unevenly, the total operation time is prolonged.)
(2) Whether the drain hose is placed too high due to threshold,
etc.
[If the drain hose is placed too high, large volume of
bubbles are generated during the RINSE or SPIN process
and the spin speed does not increase properly. In such
case, [fill water
→
stirring time (1 min.)
→
drain] processes
are automatically activated, and the operation time will be
prolonged for these processes.]
Diagnosis
Poor drain
No drain
Hard to drain
6
At end of rinse or
washing operation,
reverse rotation
period is short.
7
Washing operating
time is longer than
usual.
Remedy
Make a gap.
Replace the drain hose if it
collapses.
Make a gap.
Cut the drain hose
obliquely.
This is not trouble.
This is not trouble.
Make sure whether it is
placed on a firm and flat
floor.
Same as
5
- (2).
A gap should
be more than 3 cm.
A gap
Cut the drain
hose obliquely.
A gap should
be more than 3 cm.
A gap
A gap should
be more than 3 cm.
Rubber pipe