17
If the filling water becomes not good
The water inlet may be blocked by foreign
objects. Remove the water supply hose
and clean the filter with a brush.
•
If you remove the water supply care-
lessly, water may splash. Therefore, use
the following procedure.
Removing the water supply hose
1 Turn the water faucet off.
2 Turn the power switch ON and press
the START/HOLD pad.
3 After indicating the water level,
loosen the hose nut of the machine
top and remove it.
In case of water may freeze
Drain all water from the
basket, drainage hose
and water supply hose
after using the machine.
If the water is frozen
1 Remove the water supply hose and pour in warm water (under 40°C).
2 Fill warm water (under 40°C) into the basket until the pulsator is
completely covered. Leave it for 30 minutes. Then check to see whether
the pulsator can be turned by hand.
under 40°C
Water
intake valve
Filter
INSTALLATION
Installing the bottom cover
Put the bottom cover into the bottom of the washing machine, and fix the bottom cover with screws.
1 Lay down the washing machine on a flat object such as a
corrugated board so that the front side is down.
2 Align the bottom cover with the taps of the hooks of the
bottom cover left & right. (4 taps)
FRONT
FRONT
3 Fasten the screws on 6 positions.
BOTTOM COVER (RIGHT)
SUPPORT PLATE
BOTTOM COVER (LEFT)
*The service technician will mount the bottom cover when installing the unit.