11
INSTALLATION
Install your washing machine in a level, stable place.
•
It is dangerous to place the washing machine in an
unstable location, since it may move during vibration.
•
It will increase the sound produced by the machine when it
vibrates during use.
When you move washing machine, hold the handles on
the sides.
There are moving parts, electrical parts and steel plates
which may cause electrical shock or injury.
•
Never touch on the cabinet bottom by hands.
Never lift at the cabinet bottom by hands.
When the machine is covered.
Do not use the cover made of chloric vinyl. Sometimes it
damages resinous parts and painted surface. When you use
the cover made of chloric vinyl, put the cloth between the
machine and the cover.
Avoid place where the machine is exposed to direct sun-
light.
•
Plastic parts may become deformed or discolored.
Avoid places where the machine may become frozen
during cold weather.
Allow a space of at least 5 cm from the sides and rear of
the machine to the nearest vertical object.
•
When placed too near to walls or other objects, the
vibration of the machine during operation may cause them
to shake.
Allow 5 cm
Choosing an installation location
Installation
Adjust the legs so that the body of your washing machine is level. (The two legs are adjustable.)
After loosening the adjusting
nut, adjust the leg to the proper
height by turning it. Then
tighten the adjusting nut se-
curely once again.
When the leg height is difficult to
adjust because of floor slope or
unevenness, place a board of
sufficient thickness to prevent
breakage under the affected legs
to allow adjustment to a level po-
sition.
A weight attached to a string may be used
to check to ensure that your washing
machine is level. The distance is less than
1 cm between A and B
1
2
3
Lower
Leg nut
Tighten
Loosen
Leg
Raise
Installing the bottom cover
Put the bottom cover into the bottom of the washing machine, and fix the bottom cover with screws.
1 Lay down the washing machine
2 Align the bottom cover with
3 Fasten the screws on 6 positions.
on a flat object such as a corrugated board
the taps of the hooks of the
so that the front side is down.
bottom cover left & right. (4 taps)
BOTTOM C OVE R (R IG HT) S UPPOR T PLATE
BOTTOM C OVE R (LE FT)
FR ONT
FR ONT
String
Check the distance
6348100701 (11-15)
22/10/08, 11:19
11
