English
8
Connections and controls
If the power-on light is unlit press the POWER button
underneath the bottom left corner of the TV to switch the
set on, then press a number button on the remote
control to see the screen, it may take a few moments.
To put the set into Standby press
i
on the remote
control. To view the TV press
i
again or any of the
number buttons. The picture may take a few seconds to
appear. Standby should only be used for short periods
of time.
To set up the TV you will now need to use the on-screen
menus. Press the
MENU
button on the remote control to
see the menus.
The menu bar at the top of the screens will show five
different topics shown in symbols. As each symbol is
selected by pressing the
S
or
R
button on the remote
control, its respective options will appear below.
To use the options press the
Q
button on the remote
control to move down through them and
OK
,
S
or
R
to
select the required choice. Follow the on screen
instructions. The functions of each menu are described in
detail throughout the manual.
A wide variety of external equipment can be connected via the sockets located on the front of the TV.
Whilst all the necessary adjustments and controls for the TV are made using the remote control, the buttons on
the TV may be used for some functions.
To alter the volume press
—
j
+
.
To alter the programme position press
e
e
F
f
f
.
Press
MENU
and
S
,
R
,
Q
or
P
to control the sound
and picture options.
Press
MENU
to finish.
When connecting mono sound equipment to
EXT 6
,
connect the audio output of the equipment to the
L/Mono socket on the TV.
To select the Input, press
B
until the display shows
EXT6
as described on
page 40.
The TV will automatically
sense the type of signal.
Please always refer to the owner’s manual of the
equipment to be connected for full details.
Please note:
Inserting the headphone jack will mute the
sound from all speakers.
Switching on
Using the controls and connections
Power Button
Press the centre of
the flap to open it
Press the centre of
the flap to open it
RED – Power On
GREEN – On-timer set
INPUT 6
(EXT 6)