Toshiba 1550, Руководство по обслуживанию

Страница: 203 / 212

Mar. 1998 © TOSHIBA 18 - 7 1550/1560 UNPACKING PROCEDURE
%
%
%
%
200%
50%
1
PRINT
%
200%
ZOOM
50%
78% 129%
LT-R
LT-R
COMP
LG
COMP
LD
154%
ST-R
COMP
LG
200%
ST-R LD
LG LD
65%
ST-R LT-R
50%
ST-R LD
LT-R LD
%
(4) Press the
100%
key to set at 100% mode.
(5) To check the current image density, press
the ENERGY SAVER key to make
a test copy.
(6) If the image density is not appropriate, make
adjustment using the following procedure:
(7) Key in code “1” from the 10-key pad and
press the PRINT key.
• The current adjustment value is shown
on the display.
(8) If the image density is too high, increase
the value by using the ZOOM UP
200%
key.
(9) If the image density is too low, reduce the
value by using the ZOOM DOWN
50%
key.
(10) Press the INTERRUPT key to cause
the new value on the display to be memo-
rized.
• After you press the key, the display re-
turns to “AJ”.
• Press the ENERGY SAVER key
to make a test copy.
(11) If the image density is not appropriate, re-
peat steps (7) – (10) above.
2.2 Adjustment of manual exposure (50%, 154%
and 200%)
Note: Before performing manual exposure ad-
justment (50%, 154% and 200%), check
to make sure that manual exposure ad-
justment for 100% has been properly
done.
(1) Make copies at 154%, 50% and 200% re-
production ratios, respectively. (In the “AJ”
mode, if you press the ENERGY SAVER
key, copies will be made.)
(2) If the image density is not appropriate for
certain reproduction ratios, perform manual
exposure adjustments (a), (b) or (c) in Sec.
2.4 for the inappropriate ratios.
Digital key
a)
b)
c)
e)
d)