TORXUN AUTOPED 10, Руководство пользователя, Страница: 16 / 43

Autoped/ M10 APPENDIX rev 0 (09221 DRAFT)
A-16
III. ADJUSTING CLOSING SPRING PRELOAD
The AUTOPED operator is equipped with a closing spring that
aids in the closure of the gate/door and to maintain closing speeds
while the gate/door is in manual mode. When power to the
operator is cut or turned off, the closing spring will allow the
Door/Gate to close in a controlled manner, fully latching the door
lock system.
The tension of the spring is responsible for regulating the amount
of pressure the door requires to be pushed open before the
“Push
and Go
” assist takes over
.
Preload adjustment is done by turning the Adjusting Screw. By
default, distance
X between top of head of Adjusting Screw and
spring bracket is:
X = 1-1/32 inch (26 mm)
To adjust the Closing Spring Preload:
STEP 1 Swing Door/Gate panel open to about 60º
STEP 2 Allow panel to close on its own
STEP 3 Check to see if Door/Gate latches on full lock
STEP 4 Adjust distance X according to Table II.3 (below)
STEP 5 Repeat the above steps if needed
Table II.3 Preload
X Values
Door/Gate
panel width
37” 43” 49” 55” 63”
Standard push arm
Measure “
X
”
1-
9/16” 1-7/16” 1-1/4”
1-
1/16” 7/8”
Optional slide arm
Measure “
X
”
1-
7/16” 1-5/16” 1-1/16” 3/4” 11/16”