20 |
P a g e
Factory Reset Procedure
1.
Disconnect the Ethernet cable from the AVR.
2.
Turn the power switch to the OFF position. The power light will go out.
3.
Press and hold the little pushbutton switch below the front panel display on the AVR.
4.
Continue to hold the pushbutton switch and turn the power switch to the ON position. Hold the
pushbutton switch for approximately 30 seconds and then release the pushbutton switch.
5.
Use the pushbutton as you would normally to scroll through the various screens until you get to the
IP address screen and it should now show as 0.0.0.0.
6.
Plug in the Ethernet cable. The IP address should change to a value appropriate for your new
network setup as the unit’s network configuration is now set to factory default as DHCP.
7.
You can then use this new IP address to access the unit as you did previously if you wish to assign it
a new static IP address.
Содержание AVR2 ELITE 16 520R
