TorsionX
PWRPAX-115/220 Multi-Port Power Pack (Updated 10/01/21)
6
Hydraulic Connections:
1.
Inspect all hydraulic twin line hoses, threads and fittings for signs of wear or damage
and replace as needed.
2.
Clean all hose ends and hydraulic couplers.
3.
Connect the twin line hydraulic hose to the hydraulic torque wrench and the power
pack, making sure all hydraulic couplers are snug.
4.
Jog the power pack several times.
a.
The power pack is now ready to be put into regular operation.
Adjusting the Hydraulic Pressure:
NOTE:
For easy adjustment of the pressure
regulating valve always adjust the pressure by
increasing to the desired pressure setting.
1.
Loosen the locknut on the pressure
regulating valve, and back the adjusting
knob out a few turns.
a.
Do so by turning the adjusting
knob in a counterclockwise
direction. (Figure 2)
b.
This will decrease the pressure setting to a pressure lower than the desired
pressure.
ATTENTION: THE POWER PACK MUST BE COMPLETELY CONNECTED AND THE HYDRAULIC
TORQUE WRENCH MUST NOT BE ON THE APPLICATION WHEN ADJUSTING THE PRESSURE.
2.
Connect the electric power supply and flip the on/off switch to “On”
a.
This switch is located on the side of the electrical control box.
3.
Press the top of the rocker switch on the remote control handle to turn the power pack
on.
a.
The power pack will deliver hydraulic oil to the low pressure port (Port B).
4.
Press and hold the top of the rocker switch further to engage the momentary “Advance”
switch.
a.
The power pack will deliver hydraulic oil to the high pressure port (Port A).
5.
While holding remote rocker in the “Advance” position, slowly turn the adjusting knob
in a clockwise direction.
a.
This will gradually increase the pressure setting.
6.
When the desired pressure is reached, lock the adjusting knob in position by tightening
the locknut.
IMPORTANT: NEVER EXCEED 10,000 PSI (700 BAR)
Figure 2
