TorsionX
PWRPAX-115/220 Multi-Port Power Pack (Updated 10/01/21)
5
IF YOU ARE USING AN EXTENSION CORD TO POWER THE HYDRAULIC PUMP, USE A HEAVY
GAUGE CORD (12 GAUGE OR BETTER).
Operation Warnings:
•
Before performing any maintenance, disconnect power pack from power.
•
Do not
permit anyone to stand in front of open hydraulic couplers during operation.
•
Never
exceed the maximum operating pressure of 10,000 PSI (700 BAR).
•
Do not
operate without oil.
•
Keep the power pack clean.
Set Up
Hydraulic Oil:
Attention:
The power pack has been shipped
without
oil in the reservoir. Only use a high-
quality, non-foaming hydraulic oil, which meets the following requirements:
•
Cleanliness Level:
o
ISO 4406:
17/15/12
o
NAS 1638:
6
o
SAE 749:
3
•
ISO Viscosity Grade:
o
Cold Climates:
32
o
Temperate Climates:
46
o
Tropical Climates:
68
Filling the Reservoir:
1.
Place PWRPAX on level surface.
2.
Clean the area around the filler cap.
a.
Any dirt or grime in the hydraulic oil can damage the internal workings of the
power pack.
3.
Remove the filler cap, and insert a clean funnel.
4.
Fill with appropriate hydraulic oil until oil above red dot in sight-glass window.
5.
Replace filler cap.
6.
Cycle the power pack (with hydraulic torque wrench attached) several times.
7.
Retract the hydraulic torque wrench and check the oil level in the power pack reservoir
again.
a.
This will also help eliminate air from the system.
