Torqeedo Travel 401 L, Руководство по эксплуатации

Страница: 14 / 28

14
Operating Manual Travel 401/801
• Make sure you do not crush the control cable.
• Do not place the transom mount onto the shaft above the deadbolt to
avoid damage to the shaft and the transom mount.
• Only fix the battery pack once the drive has been mounted and
straightened.
8.2 Fitting the outboard motor to the boat
1. Suspend the drive in your boat and tighten the capstan-head screws. Ensure the
weight is spread evenly in the boat.
2. To trim the motor, pull the stopper button of the transom mount and position the
folding shaft vertically to the water surface.
. To adjust the shaft length, loosen both wing nuts on the transom bracket and adjust
the shaft length to your boat so that the propeller has the required submergence depth.
Note that the submergence depth has a major influence on the efficiency of your drive.
To optimize the submergence depth, please read the operating instructions in section 9.5.
4. To adjust the height of the tiller, loosen the respective wing nuts and pull the tiller to
the required height. Once you have the required height, tighten the wing nuts again.
5. The tiller handle can be adjusted in length by pressing the opening button. Ensure that
the button engages.
6. Turn the tiller handle to the stop position until
it engages.
7. Fit the battery pack. To do this, lift it with both
hands and fit it into the shaft head from above.
Then swing the battery to the rear until it sits
properly and engages.