3
ASSEMBLY AND OPERATING INSTRUCTIONS
STEP 1
Tag-a-long arm
1. Extend the Tag-a-long arm until the two sections meet flush.
2. Insert the quick release through the two sections and tighten securely. The quick release
should be secured very firmly in place.
STEP 2
Attach the handlebar
1. Unscrew all four screws using a 5mm Allen key.
2. Place the handlebar into the stem.
3. Insert all four screws back into the clamp, and tighten with your fingers.
4. Adjust the handlebar to the desired position and tighten all screws securely with the Allen key.
IMPORTANT NOTE: As you tighten the screws, alternate among all four to make sure they
are tightened evenly. When properly tightened, the handlebar should not move.
STEP 3
Attach the handlebar pad
1. Remove the cover from the foam pad and slide the foam pad over the handlebar crossbar so
the opening is on the bottom.
2. Wrap the cover around the foam pad and secure along the bottom edge.
