Toro Z597-D Z Master, Руководство оператора

Страница: 59 / 68

Removing the Blades
Blades must be replaced if a solid object is hit,
if the blade is out of balance or is bent. To
ensure optimum performance and continued
safety conformance of the machine, use genuine
TORO replacement blades. Replacement blades
made by other manufacturers may result in
non-conformance with safety standards.
Contact with a sharp blade can cause serious
injury.
Wear gloves or wrap sharp edges of the
blade with a rag.
1. Hold the blade end using a rag or
thickly-padded glove.
2. Remove the blade bolt, spring disk and blade
from the spindle shaft (Figure 83).
Sharpening the Blades
When sharpening blade, pieces of blade
could be thrown and cause serious injury.
Wear proper eye protection when sharpening
blade.
1. Use a file to sharpen the cutting edge at both
ends of the blade (Figure 81). Maintain the
original angle. The blade retains its balance if
the same amount of material is removed from
both cutting edges.
Figure 81
1. Sharpen at original angle
2. Check the balance of the blade by putting it on
a blade balancer (Figure 82). If the blade stays
in a horizontal position, the blade is balanced
and can be used. If the blade is not balanced,
file some metal off the end of the sail area only
(Figure 83). Repeat this procedure until the
blade is balanced.
Figure 82
1. Blade 2. Balancer
Installing the Blades
1. Install the blade onto the spindle shaft
(Figure 83).
Important:
The curved part of the blade
must be pointing upward toward the inside
of the mower to ensure proper cutting.
2. Install the spring disk and blade bolt. The
spring disk cone must be installed toward the
bolt head (Figure 83). Torque the blade bolt to
85-110 ft-lb (115-150 N•m).
Figure 83
1. Sail Area of Blade 4. Blade Bolt
2. Blade 5. Cone Towards Bolt Head
3. Spring Disk
59