Toro Z590 Z Master, Инструкции по установке

Страница: 3 / 12

Figure 4
4. Mount the wheels with the valve stem to the outside
and secure them with the wheel nuts previously
removed.
5. Torque the wheel nuts to 95 ft-lb (128 N·m).
6. Remove the jack-stands.
Figure 5
4
Installing the Roll Over
Protection System
Parts needed for this procedure:
1 Roll bar, right section
1 Roll bar, left section
1 Roll bar, center section
8 Bolt, (3/8 x 1 inch)
8 Curved washer
8 Flange nut, (3/8 inch)
2 Bolt, (1/2 x 3–1/4 inch)
2 Flange nut, (1/2 inch)
Procedure
1. Loosely install the right and left roll bar section to
the frame, with 8 bolts (3/8 x 1 inch), 8 curved
washers, and 8 flange nuts (3/8 inch).
Note:
The curve washer cone must be installed
toward the bolt head.
Figure 6
2. Install the lanyard clips onto the long bolts (1/2 x
3-1/4 inch).
Note:
Make sure the bent tab points toward the
head of the bolt.
Figure 7
3. Lightly oil the ends of the center roll bar section.
4. Loosely install the center roll bar section using 2
bolts (1/2 x 3-1/4 inch) and 2 flange nuts (1/2 inch).
Note:
Make sure the bolts are installed from the
outside of the roll bar.
Note:
Make sure the lanyard tab is installed as
shown and points forward.
3