Toro Z590-D Z Master, Руководство оператора

Страница: 51 / 68

9. Apply slight rearward pressure on the motion
control lever, turn the head of the adjustment bolt
in the appropriate direction until the control lever is
centered in the neutral lock position (Figure 74).
Note:
Keeping rearward pressure on the lever will
keep the pin at the end of the slot and allow the
adjustment bolt to move the lever to the appropriate
position.
10. Tighten the nut and jam nut (Figure 74).
11. Repeat for the opposite side of the machine.
Figure 74
1. Clevis pin in slot 7. Spring
2. Nut against yoke 8. Pivot shaft
3. Adjustment bolt 9. Yoke
4. Pump rod 10. Locknut
5. Double nuts 11. Ball joint
6. Jam Nut 12. Tracking knob
Hydraulic System
Maintenance
Servicing the Hydraulic
System
Hydraulic Oil Type: Toro ® HYPR-OIL ™ 500
hydraulic oil or Mobil ® 1 15W-50
Hydraulic System Oil Capacity: 132 ounces (3.9l)
Important:
Use oil specified. Other fluids could
cause system damage.
Checking the Hydraulic Fluid
Service Interval: After the first 8 hours
Every 25 hours
Note:
There are two ways of checking the hydraulic oil.
One is when the oil is warm and one is when the oil is
cold. The baffle inside the tank has two levels depending
if the oil is warm or cold.
1. Position the machine on a level surface and set the
parking brake.
2. Clean the area around filler neck of hydraulic tank
(Figure 75).
3. Remove the cap from the filler neck. Look inside to
check if there is fluid in the reservoir (Figure 75).
4. If there is no fluid, add fluid to the reservoir until it
reaches the cold level of the baffle.
5. Run the machine at low idle for 15 minutes to allow
any air to purge out of the system and warm the
fluid. Refer to Starting and Stopping the Engine in
Starting and Stopping the Engine (page 19).
6. Recheck the fluid level while the fluid is warm. The
fluid should be between cold and hot.
7. If required, add fluid to the hydraulic tank.
Note:
The fluid level should be to the top of the hot
level of the baffle, when the fluid is hot (Figure 75).
8. Install cap on filler neck.
51