Toro Z590-D Z Master, Руководство оператора

Страница: 29 / 68

Figure 34
1. Trailer 3. Not greater than
15 degrees
2. Full width ramp 4. Full width ramp—side view
Using the Z Stand®
The Z Stand raises the front end of the machine to
allow you to clean the mower and remove the blades.
WARNING
The machine could fall onto someone and cause
serious injury or death.
• Use extreme caution when operating the
machine on the Z Stand®.
• Use only for cleaning the mower and removing
the blades.
• Do not keep the machine on the Z Stand for
extended periods of time.
• Always turn the engine off, set the parking
brake, and remove the key before performing
any maintenance to the mower.
Driving up onto the Z Stand
Important:
Use the Z Stand on a level surface.
1. Raise the mower to the transport position.
2. Remove the bracket pin (Figure 35).
Figure 35
1. Z Stand 4. Bracket Pin
2. Latch 5. Bottom of slot
3. Bracket
3. Raise the latch. Swing the stand foot out front and
slide stand toward machine, into the bottom of slot
(Figure 35 and Figure 36).
4. Lengthen the Z Stand by removing the clevis pin
and hairpin cotter pin from the outer tube and
sliding the foot out.
5. Align the holes and install the clevis pin and hairpin
cotter pin.
Figure 36
1. Z Stand (Positioned in
slot) 3. Latch resting on pivot tab
2. Crack in side walk or turf
6. Set the foot of stand on the ground and rest the
latch on the pivot tab (Figure 36).
7. Start the engine and put it at half throttle.
Note:
For best results, place the foot of stand into
seams in sidewalks or into the turf (Figure 36).
8. Drive onto the stand. Stop when the latch drops
over the tab into the locked position (Figure 36).
Once onto the stand, engage the parking brake and
tun off the engine.
9. Chock or block the drive wheels.
29