Toro Z449 Z Master, Руководство оператора

Страница: 47 / 60

Figure 60
1. Measure here from blade
to hard surface
2. Measure at B and C
7. If the measurements at positions B or C are
not correct, loosen the bolt attaching the rear
chain to the rear support arm (Figure 61).
8. Loosen the jam nut under the rear support
arm and adjust the adjustment bolt to get
a measurement of 3-1/8 to 3-1/4 inches
(Figure 61).
Note:
It is recommended that both sides of
the mower are adjusted the same distance.
9. Tighten the jam nut under the rear support
arm and tighten the bolt securing the chain to
the rear support arm.
10. Adjust the opposite side if needed.
Figure 61
1. Rear chain 5. Adjustment bolt
2. Rear support arm 6. Front swivel
3. Bolt
7. Front support arm
4. Jam Nut
Adjusting the Front-to-Rear Mower
Pitch
1. Position the right blade front-to-rear
(Figure 62).
2. Measure the right blade at the A location, from
a level surface to the cutting edge of the blade
tip (Figure 62).
Figure 62
1. Measure here from blade
to hard surface
2. Measure at A and B
3. Record this measurement.
47