Toro Z255 Z-Master, Руководство оператора

Страница: 27 / 68

Operation
25
Releasing the Parking Brake
1. Push forward and down on the parking brake
lever to release the parking brake (Fig. 2). The
parking brake is “DISENGAGED” and the lever
rests against the brake stop.
1
2
3
Figure 2
1. Parking brake-ON
2. Parking brake-OFF
3. Brake Stop
Starting and Stopping
the Engine
Starting
1. Sit on the seat and move the motion controls to
neutral locked position.
2. Set the parking brake; refer to Setting the
Parking Brake, page 24.
3. Move the PTO (power take off) switch to “OFF”
(Fig. 3).
4. Move the choke control to “ON” position before
starting a cold engine.
Note: A warm or hot engine may not require
choking. After engine starts, move
choke control to “RUN” position.
5. Move the throttle control to the “FAST” position
before starting a cold engine.
6. Turn ignition key “START” to energize starter.
When engines starts, release key.
IMPORTANT: Do not engage starter for
more than 10 seconds at a time. If engine fails
to start allow 30 second cool-down period
between attempts. Failure to follow these
instructions can burn out the starter motor.
7. After the engine starts, move the choke to “OFF”
(Fig. 4). If the engine stalls or hesitates, move
the choke back to “ON” for a few seconds. Then
move the throttle lever to desired setting. Repeat
this as required.
Figure 3
1. PTO-On
2. PTO-Off
Figure 4
1. Choke–On
2. Choke–Off
1
m–2719
2
1
2
m–4201
Figure 5
1. Throttle–Fast
2. Throttle–Slow
Figure 6
1. Off
2. Run
3. Start
2
1
m–2720
1
2
3
M-4268