Toro Z Master Z597, Руководство по обслуживанию

Страница: 194 / 198

7-47 Z Master 597 Diesel Series Service Manual
7
MOWER DECKS
5. Lower the mower to the 3 inch (76mm) height-of-cut
position.
6. Inspect the four chains. The chains need to have
tension.
• If one rear chain is loose, lower (loosen) the front
support arm on the same side. Refer to Adjusting
the Front-to-Rear Mower Pitch on page 7-48.
• If one front chain is loose, raise (tighten) the front
support arm for that chain. Refer to Front-to-Rear
Mower Pitch on page 7-48.
Leveling the Mower Side-to-Side
1. Position the right blade side-to-side (Fig. 557).
Fig 557 fig. 65 m-1078
2. Measure the right blade at the B location (Fig. 557),
from a level surface to the cutting edge of the blade
tip (Fig. 558).
Fig 558 fig. 66 m-2539
3. Record this measurement. This measurement needs
to be 3-1/8 to 3-1/4 inches (7.9 to 8.3cm).
4. Position the left blade side-to-side (Fig. 557).
5. Measure the left blade at the C location (Fig. 557)
from level surface to cutting edge of the blade tips
(Fig. 558).
6. Record this measurement. The measurement needs
to be 3-1/8 to 3-1/4 inches (7.9 to 8.3cm).