33
7. Rotate oil drain valve to allow oil to drain (Fig. 32).
1
2
Figure 32
1.
Oil drain valve
2.
Drain hose
8. When oil has drained completely, close the drain valve.
9. Remove the drain hose (Fig. 32).
Note: Dispose of the used oil at a recycling center.
10. Slowly pour approximately 80% of the specified oil
(refer to Service Interval/Specification on page 32) into
the filler cap (Fig. 31).
11. Check the oil level; refer to Checking the Engine Oil
Level on page 32.
12. Slowly add the additional oil to bring it to the Full
mark.
Changing the Oil Filter
Replace the oil filter every 200 operating hours or every
other oil change.
Note: Change the oil filter more frequently when the
operating conditions are extremely dusty or sandy.
1. Drain the oil from the engine; refer to Changing the Oil
on page 32.
2. Remove the old oil filter (Fig. 33).
2
m–7451
1
Figure 33
1.
Oil filter
2.
Adapter
3. Apply a thin coat of new oil to the rubber gasket on the
replacement filter (Fig. 33).
4. Install the replacement oil filter to the filter adapter,
turn the oil filter clockwise until the rubber gasket
contacts the filter adapter, then tighten the filter an
additional 3/4 turn (Fig. 33).
5. Fill the crankcase with the proper type of new oil; refer
to Servicing the Engine Oil on page 32.
6. Run the engine for about 3 minutes, stop the engine,
and check for oil leaks around the oil filter.
7. Check the engine oil level and add oil if needed.
Servicing the Spark Plug(s)
Service Interval/Specification
Check the spark plug(s) after every 100 operating hours.
Ensure that the air gap between the center and side
electrodes is correct before installing the spark plug(s). Use
a spark plug wrench for removing and installing the spark
plug(s) and a gapping tool/feeler gauge to check and adjust
the air gap. Install a new spark plug if necessary.
Type: Champion
RCJ-8Y or equivalent
Air Gap: 0.030 inch (0.75 mm)
Removing the Spark Plug(
s)
1. Disengage the PTO and set the parking brake.
2. Stop the engine, remove the key, and wait for all
moving parts to stop before leaving the operating
position.
3. Disconnect the wire(s) from the spark plug(s) (Fig. 34).
m–7453
1
Figure 34
1.
Spark-plug wire/spark plug
4. Clean around the spark plug(s) to prevent dirt from
falling into the engine and potentially causing damage.
5. Remove the spark plug(s) and the metal washer(s).
