Toro Workman MDE 2008, Руководство по обслуживанию

Страница: 33 / 130

Workman MDE
Page 3 -- 15
Electrical System
Battery Discharge Indicator and Hour Meter Gauge
The combination battery discharge indicator and hour
meter gauge is located on the dash panel (Fig. 19).
The battery indicator identifies state of charge of the bat-
tery pack. The battery indicator reads full (10 bars) when
the battery pack is fully charged (approximately 51
volts). As battery pack voltage decreases with vehicle
use, fewer battery indicator bars are shown.
When the battery indicator reaches 2 bars, a warning
light illuminates and a battery icon flashes on the gauge
face to identify that battery charge level is extremely low.
At this point, the batteries should be charged.
If the battery indicator reaches 1 bar, the warning light
begins flashing and the vehicle will go into an energy
saving mode: vehicle speed will be reduced to 3 MPH.
At this point, the batteries should be charged to prevent
serious battery damage.
The hour meter registers operating time of the vehicle.
Whenever the vehicle is in motion, the hour meter
should increase one tenth every six (6) minutes of op-
eration. If the vehicle remains stationary for thirty (30)
seconds (even if the on/off switch is ON), the hour meter
quits increasing.
The back of the gauge is shown in Figure 20. A wire har-
ness connector plugs into the gauge. Terminals 1, 2 and
5 are not used on the Workman MDE. See Chapter 6 --
Electrical Diagrams for schematic and wire harness in-
formation.
If the battery discharge indicator or the hour meter prove
to be inaccurate, the gauge should be replaced.
1. Battery discharge indicator and hour meter
Figure 19
1
Figure 20
1 4
8 5
BACK OF
GAUGE
Electrical System