Toro Workman MDE 07299, Руководство оператора

Страница: 20 / 44

Operation
Note:
Determine the left and right sides of the machine
from the normal operating position.
Think Safety First
Please carefully read all of the safety instructions and decals
in the safety section. Knowing this information could help
you or bystanders avoid injury.
Performing the Pre-Start
Checks
Each day, preform the following pre-start checks before using
the machine:
•
Check brake fluid levels, and add the specified brake
fluids as needed; refer to
Checking the Brake Fluid Level
(page 20) .
•
Check the air pressure in the tires; refer to Checking the
Tire Air Pressure (page 21) .
•
Check the brake pedal operation.
•
Check to see that the lights are working.
•
Turn the steering wheel to the left and right to check
steering response.
•
Check for loose parts and any other noticeable
malfunctions. Make sure that the machine is off and all
moving parts have stopped before checking for loose
parts and other wear and damage.
If any of the above items are not correct, notify your mechanic
or check with your supervisor before taking the machine out
for the day. Your supervisor may want you to check other
items on a daily basis, so ask what your responsibilities are.
Checking the Brake Fluid
Level
Service Interval: Before each use or daily Check the
brake-fluid level before the motor is first
used.
Brake Fluid Type: DOT 3
1. Park the machine on a level surface, set the parking
brake, rotate the On/Off switch to the Off position,
and remove the key..
2. Remove the rubber plug in the center and on top of
the dash to gain access to the master brake cylinder
and reservoir (
Figure 13 ).
Figure 13
1. Rubber plug 3. Filler neck (reservoir)
2. Reservoir cap 4. DOT 3 brake fluid
3. Look at the outline of the fluid level at the side of the
reservoir. (
Figure 14 ).
Note:
The level should be above the Minimum line
Figure 14
1. Brake-fluid reservoir
2. Minimum line
4. If the fluid level is low, perform the following:
A. Clean the area around the reservoir cap, and
remove the cap (
Figure 13 ).
B. Add DOT 3 brake fluid to the reservoir until the
fluid level is above the Minimum line (
Figure 14 ).
Note:
Do not overfill the reservoir with brake
fluid.
C. Install the reservoir cap ( Figure 13 ).
5. Install the rubber plug in top of the dash ( Figure 14 ).
20