Setup
Loose Parts
Use the chart below to verify that all parts have been shipped.
Procedure
Description
Qty.
Use
Steering wheel
1
Cover
1
1
Washer (1/2 inch)
1
Install the steering wheel (TC models
only).
2
No parts required
–
Connect the battery (TC models only).
3
No parts required
–
Check the fluid levels and tire pressure.
4
No parts required
–
Burnish (break-in) the brakes.
Operator's Manual
1
Engine owner's manual
1
Registration card
1
Predelivery Inspection Form
1
Certificate of Quality
1
5
Key
2
Read the Operator's Manual and view
the setup material before operating the
machine.
Note:
Determine the left and right sides of the machine from the normal operating position.
1
Installing the Steering
Wheel
TC Models Only
Parts needed for this procedure:
1
Steering wheel
1
Cover
1
Washer (1/2 inch)
Procedure
1.
If the cover is installed, remove it from the hub
of the steering wheel (
).
2.
Remove the locknut (1/2 inch) from the steering
shaft (
3.
Slide the steering wheel and washer (1/2 inch)
onto the steering shaft (
).
4.
Secure the steering wheel to the shaft with the
locknut (1/2 inch) and tighten it to 27 to 34 N∙m
(20 to 25 ft-lb).
5.
Install the cover on the steering wheel (
).
g033840
Figure 3
1.
Cover
4.
Steering wheel
2.
Locknut (1/2 inch)
5.
Steering shaft
3.
Washer (1/2 inch)
7