Toro Workman 07235, Руководство оператора

Страница: 48 / 60

10. Check the fluid level and add more fluid if the
level is below the threads of the fill-plug hole
(
Figure 59 ).
Checking and Adjusting
Neutral
Service Interval: Every 100 hours
When performing routine maintenance and/or engine
diagnostics, the transaxle must be shifted into
N
EUTRAL
( Figure 61 ). The machine has a N
EUTRAL
position on the shift lever, which controls the neutral in
the transaxle. Perform the following steps to ensure
that the neutral shift lever operates the transaxle
neutral correctly:
1. Set the shift lever into the N
EUTRAL
position.
2. Ensure that the neutral bracket is in the N
EUTRAL
position (level to the cable mounting bracket
located below the shift bracket) by turning the
driven clutch (
Figure 61 ).
Note:
The machine should not roll back and
forth. If it does, manually move the neutral
bracket to the N
EUTRAL
position.
g002093
Figure 61
1. Neutral bracket 2. Locknuts
3. Rotate 1 of the locknuts ( Figure 61 ) to achieve
a 0.762 to 1.524 mm (0.030 to 0.060 inch) gap
between the bottom of the nut/washer and the
neutral bracket.
Note:
You must hold the threaded shaft below
the bracket when adjusting the locknut position
on top.
4. Rotate the other locknut to achieve a 0.76
to 1.52 mm (0.03 to 0.06 inch) gap between
the bottom of the nut/washer and the neutral
bracket.
5. Pull up on each shift cable an ensure that there
is a 0.76 to 1.52 mm (0.03 to 0.06 inch) between
the nut/washer and the neutral bracket (
Figure
62 ).
Note:
If there is a not a gap, adjust the nuts to
achieve the specified gap.
g002094
Figure 62
1. Neutral bracket 4. 0.76 to 1.52 mm (0.03 to
0.06 inch) gap
2. Pull up 5. Wrong —adjust the to
achieve a gap of 0.76 to
1.52 mm (0.03 to 0.06
inch) inch
3. Cable boot
6. Start the engine and shift into F
ORWARD
,
R
EVERSE
, and N
EUTRAL
several times to ensure
that the neutral bracket is operating properly.
Maintaining the
Primary-Drive Clutch
Service Interval: Every 400 hours/Yearly (whichever
comes first)
CAUTION
The dust in the clutch will become airborne
and could damage your eyes or you could
inhale it, causing breathing difficulties.
Wear safety goggles and a dust mask or
other eye and respiratory protection when
performing this procedure.
1. Raise and latch the cargo bed; refer to Raising
the Cargo Bed (page 18) .
2. Remove the 3 bolts securing the cover to the
clutch, and remove the cover (
Figure 63 ).
Note:
Retain the cover and bolts for installation.
48