Toro Workman 07040, Руководство оператора

Страница: 30 / 56

Lifting the Machine
DANGER
The machine may be unstable when using
a jack. The machine could slip off the jack,
injuring anyone beneath it.
• Do not start the machine while the machine
is on a jack.
• Always remove the key from the key switch
before getting off the machine.
• Block the tires when the machine is
supported by lifting equipment.
• Use jack stands to support the machine
once you have lifted it.
Important:
Whenever you run the machine for
routine maintenance and/or diagnostics, ensure
that the rear wheels of the machine are 25 mm (1
inch) off the ground, with the rear axle supported
on jack stands.
•
The lifting point at the front of the machine is
located at the front of the frame, behind the towing
tongue (
Figure 23 ).
g034043
Figure 23
1. Front lifting point
•
The lifting point at the rear of the machine is
located under the axle tubes (
Figure 24 ).
g034044
Figure 24
1. Rear lifting points
Accessing the Hood
Raising the Hood
1. Lift up the handle of the rubber latches on each
side of the hood (
Figure 25 ).
g034045
Figure 25
2. Raise the hood.
Closing the Hood
1. Gently lower the hood.
2. Secure the hood by aligning the rubber latches
onto the latch anchors on each side of the hood
(
Figure 25 ).
30