9
DESCRIPTION
QTY.
USE
Snowthrower assembly
Lift tube
Lift rod
Spacer washer, 3/4 in.
Retainer
Washer, 5/8 in.
Hairpin cotter, 2-1/2 in.
Rod handle
Lift assist spring
Belt
Idler assembly
Clevis pin
Crank handle
Handle support
Hairpin cotter, 1-7/8 in.
Hairpin cotter, 1-7/16 in.
1
1
1
2
1
1
2
1
1
1
1
2
1
1
3
2
Installing the snowthrower to the tractor
Installing the Frame and Pulley
1. Tip the housing onto its front and insert the frame into
the snowthrower with angle bend up (Fig. 2).
1279
1
2
3
7
4
8
9
5
6
Figure 2
1.
Housing
2.
Frame
3.
Bolt, 3/8 x 1 in.
4.
Locknut, 3/8 in.
5.
Pulley hub without set
screws (install flush to
shaft end)
6.
Key
7.
Set screw
8.
Shaft
9.
Pulley
2. Fasten the frame with 4 bolts (3/8 x 1 in.) (heads to the
outside) and 4 locknuts (3/8 in.).
3. Install the key into the shaft (Fig. 2)..
4. Install the pulley so the hub without the set screws is
flush to end of the shaft (Fig. 2).
Important
The set screws must be on the inside.
5. Secure pulley to shaft with both set screws (Fig. 2).
Installing the Side and Top
Plates
1. Rotate the housing down and position the top plate
outside the top flange of the housing, securing it with
3
long shoulder bolts (3/8 x 1 in.) (heads on the inside), 3
washers (3/8 in.), and 3 locknuts (3/8 in.) (Fig. 3).
