Toro TurfMaster 22210, Руководство оператора

Страница: 25 / 36

1. Install the first blade so that it is horizontal, along
with all mounting hardware as shown in
Figure
39 .
Note:
Tighten the bolt with your fingers.
Important:
Position the curved ends of the
blades to point toward the machine housing.
Be sure to nest the raised areas on each
blade driver with the recesses in the head of
its corresponding spindle, and the pins on
the other side of each blade driver with the
holes in its corresponding blade.
2. Steady each blade with a board and turn the
blade bolt clockwise with a torque wrench as
shown in
Figure 40 ; torque each blade bolt to
82 N∙m (60 ft-lb).
g016537
g016537
Figure 40
Important:
A bolt torqued to 82 N∙m (60
ft-lb) is very tight. Put your weight behind
the wrench and tighten the bolt securely.
This bolt is very difficult to overtighten.
3. Rotate the installed blade 1/4 turn until it is
vertical, and install the other blade in the same
manner as the first (refer to step
1 ).
Note:
The blades should be perpendicular,
forming an inverted “T” as shown in Figure 41 .
1
G016536
g016536
Figure 41
1. Blade (2)
4. Tighten the second blade; refer to step 2 .
5. Rotate the blades by hand a full 360° turn to
ensure that they do not touch.
Note:
If the blades touch each other, they are
not mounted correctly. Repeat steps 1 through 3
until the blades no longer touch each other.
Changing the Blade-Drive
Belt
Change the blade-drive belt as needed.
1. Shut off the engine and wait for all moving parts
to stop.
2. Disconnect the wire from the spark plug.
3. Remove the belt cover ( Figure 9 ) by removing
the 4 bolts that hold it to the machine housing.
Note:
Save the bolts for installing the belt cover
to the machine housing.
4. Remove any debris from under the belt cover.
5. Remove the BBC belt guard and the mounting
hardware.
Note:
Save the BBC belt guard and hardware
for installation later.
25