Toro TurfMaster 22210, Руководство оператора

Страница: 20 / 36

G019648
g019648
Figure 29
5. After draining the used oil, return the machine to
the operating position.
6. Carefully pour about 3/4 of the engine capacity
of oil into the oil-fill tube.
7. Wait about 3 minutes for the oil to settle in the
engine.
8. Wipe the dipstick clean with a clean cloth.
9. Insert the dipstick into the oil-fill tube, then
remove the dipstick.
10. Read the oil level on the dipstick ( Figure 28 ).
•
If the oil level is below the Add mark on the
dipstick, carefully pour a small amount of
oil into the oil-fill tube, wait 3 minutes, and
repeat steps
8 through 10 until the oil level is
at the Full mark on the dipstick.
•
If the oil level is above the Full mark on the
dipstick, drain the excess oil until the oil level
is at the Full mark on the dipstick.
Important:
If the oil level in the engine is too
low or too high and you run the engine, you
may damage the engine.
11. Install the dipstick securely.
12. Recycle the used oil properly.
Changing the Oil Filter
Service Interval: Every 100 hours
1. Run the engine to warm the oil.
2. Shut off the engine and wait for all moving parts
to stop.
3. Disconnect the wire from the spark plug.
4. Drain the engine oil; refer to Changing the
Engine Oil (page 19) .
5. Place a rag under the oil filter to catch any oil
that may leak out as you remove the filter.
6. Remove the oil filter ( Figure 30 ).
Note:
Make sure that the oil-filter gasket comes
off with the filter.
g019650
1
g019650
Figure 30
1. Oil filter
7. Use your finger to coat the gasket on the new
filter with oil (
Figure 31 ).
g002805
Figure 31
1. Gasket
8. Install the new filter until the gasket contacts
the filter base, then hand tighten the filter an
additional 2/3 turn.
9. Fill the crankcase to the Full line on the dipstick
with fresh oil; refer to
Changing the Engine Oil
(page 19) .
10. Connect the wire to the spark plug.
11. Run the engine for about 3 minutes.
12. Shut off the engine, wait for all moving parts to
stop, and check for oil leakage around the filter.
13. Add oil to compensate for the oil in the oil filter;
refer to
Changing the Engine Oil (page 19)
14. Recycle the used oil filter according to local
codes.
20