Toro TRX-26, Руководство оператора, Страница: 23 / 52

Premaintenance
Procedures
Before opening any of the covers, stop the engine,
remove the key, and allow the engine to cool.
Important:
The fasteners on the covers of this
machine are designed to remain on the cover after
removal . Loosen all of the fasteners on each cover a
few turns so that the cover is loose but still attached,
then go back and loosen them until the cover
comes free. This will prevent you from accidentally
stripping the bolts free of the retainers.
Removing the Cover Plate
1. Lower the boom, stop the engine, and remove the
key.
There is a belt under the cover that is moving
when the machine is running and can catch
fingers, hands, loose hair, and clothing, causing
serious injury, amputation, or death.
Always stop the engine and wait for all moving
parts to stop before removing the cover.
2. Loosen the bolt at the rear of the cover plate.
3. Loosen the three bolts securing the cover plate to the
frame sequentially until the cover is free (Figure 25).
Figure 25
1. Cover plate 2. Bolts
4. Pull up on the rear of the cover plate until it clears
the engine and then pull it off of the machine.
Installing the Cover Plate
1. Lower the boom, stop the engine, and remove the
key.
2. Slide the cover plate into place and secure it with the
three bolts you loosened previously (Figure 25).
Removing the Bottom Shield
1. Lower the boom, stop the engine, and remove the
key.
2. Loosen the two bolts securing the bottom shield
sequentially until the shield is free (Figure 26).
Figure 26
1. Bottom shield 3. Tabs
2. Bolts
3. Pull the shield back and out of the machine.
Installing the Bottom Shield
1. Lower the boom, stop the engine, and remove the
key.
2. Slide the bottom shield into the machine so that it
rests on all 4 tabs (Figure 26).
Note:
You may need to lift up on the bottom shield
to ensure that it rests on the front tabs.
3. Secure the shield with the bolts you loosened
previously.
23