Page 2
Loose Parts
Note:
Use the chart below to verify that all loose parts have been shipped.
Description Qty
Use
Warranty Registration Form
1
Fill out and return to Toro
Key, Toro Ignition
Key, Standard Ignition
1
1
Unit ignition
Hose, Connector
1
Manual, Operator’s
Manual, Parts
DVD, Titan Safety
1
1
1
Read and view before operating machine
Manual, Engine Operator’s
1
Checking Tire Pressure
1. Check the tire pressure in the drive and front
caster tires. Proper inflation for all tires is 13 psi
(90 kPa).
2. Adjust if necessary.
Fasten Seat
1. Remove the nut and bolt from the loose end of the
lanyard.
2. Tilt seat downward and align lanyard to the hole in
the side of the seat (See Figure 1).
3. Install bolt and nut. Tighten bolt and then loosen
nut 1/4-1/2 turn so that lanyard end rotates freely.
Verify that lanyard is free to rotate on both ends so
that it pulls straight while supporting the seat.
Figure 1
1. Nut
3. Bolt
2. Lanyard
4. Seat
Servicing the Battery
The machine is shipped with a filled lead
acid battery.
DANGER
POTENTIAL HAZARD
♦
Charging the battery may produce explosive
gasses
WHAT CAN HAPPEN
♦
Battery gasses can explode causing serious
injury.
HOW TO AVOID THE HAZARD
♦
Keep sparks, flames, or cigarettes away from
battery.
♦
Ventilate when charging or using battery in an
enclosed space.
♦
Make sure venting path of battery is always
open once battery is filled with acid.
1. Tilt seat up to gain access to the battery.
2. Check the voltage of the battery with a digital
voltmeter. Locate the voltage reading of the
battery in the table below and charge the battery
for the recommended time interval to bring the
charge up to a full charge of 12.6 volts or
greater.
WARNING:
Battery posts, terminals, and related
accessories contain lead compounds, chemicals
known to the State of California to cause cancer and
reproductive harm.
Wash
hands after handling.
