Toro TITAN HD 1500, Руководство оператора

Страница: 61 / 88

Installing the Battery
1. Position the battery in the tray with the terminal
posts opposite from the hydraulic tank (
Figure
82 ).
2. Install the positive (red) battery cable to the
positive (+) battery terminal.
3. Install the negative (black) battery cable and
ground wire to the negative (-) battery terminal.
Note:
For MyRide machines, ensure that the
ground cable does not rub against the trailing
arm or lower shock mount (
Figure 84 ).
g236732
Figure 84
1. Ensure that the ground
cable does not rub against
the lower shock mount. 3. Ground cable
2. Ensure that the ground
cable does not rub against
the trailing arm.
4. Secure the cables with 2 bolts, 2 washers, and
2 locknuts (
Figure 82 ).
5. Slide the red terminal boot onto the positive (+)
battery terminal.
6. Secure the battery with the rubber strap ( Figure
82 ).
Servicing the Fuses
The electrical system is protected by fuses. It requires
no maintenance; however, if a fuse blows check the
component and circuit for a malfunction or short.
The fuses are located on the right console next to the
seat (
Figure 85 ).
1. To replace the fuses, pull out the fuse to remove
it.
2. Install a new fuse ( Figure 85 ).
g036858
Figure 85
1. Fuse cover 3. Fuel-shutoff valve
2. Fuse holder
61