Toro TITAN 74891, Руководство оператора

Страница: 14 / 56

Ignition Switch
The ignition switch has 3 positions: S
TART
, R
UN
, and O
FF
..
The key will turn to the S
TART
position and move back to
the R
UN
position upon release. Turning the key to the O
FF
position shuts off the engine; however, always remove the
key when leaving the machine to prevent the engine from
accidentally starting (
Figure 5 ).
Throttle Control
The throttle control is variable between the F
AST
and S
LOW
position. Moving throttle lever forward increases engine
speed and moving throttle lever to the rear decreases engine
speed. Moving the throttle forward into the detent is full
throttle (
Figure 5 ).
Choke
Use the choke to start a cold engine. Pull the choke knob up
to engage it. Push down on the choke knob to disengage it.
Blade-Control Switch (Power Takeoff)
The blade-control switch engages and disengages power to
the mower blades (
Figure 5 ).
Hour Meter
The hour meter records the number of hours the blades
operate. It operates when the blade-control switch (PTO) is
engaged. Use these times for scheduling regular maintenance
(
Figure 5 ).
Fuel Gauge
The fuel window located below the operator position can be
used to verify the level of gasoline in the tank (
Figure 6 ).
g020264
1
Figure 6
1. Fuel-gauge window
Motion-Control Levers
The motion-control levers are speed-sensitive controls of
independent-wheel motors. Moving a lever forward or
backward turns the wheel on the same side forward or
in reverse; wheel speed is proportional to the amount the
lever is moved. Move the control levers outward from the
center to the N
EUTRAL
-L
OCK
position and exit the machine
( Figure 4 ). Always position the motion-control levers into
the N
EUTRAL
-L
OCK
position when you stop the machine
or leave it unattended.
Parking-Brake Lever
The parking-brake lever is located on left side of the console
(
Figure 4 ). The brake lever engages a parking brake on the
drive wheels. Pull the lever up and rearward to engage the
brake. Push the lever forward and down to disengage the
brake.
Foot Pedal Deck-Lift System
The foot pedal deck-lift system allows the operator to lower
and raise the deck from the seated position. You can use the
foot pedal to lift the deck briefly to avoid obstacles or lock
the deck in the highest height of cut or transport position
(
Figure 4 ).
Height-of-Cut Lever
The height-of-cut lever works with the foot pedal to lock the
deck in a specific cutting height. Only adjust the height of cut
while machine is not moving (
Figure 4 ).
Attachments/Accessories
A selection of Toro approved attachments and accessories is
available for use with the machine to enhance and expand
its capabilities. Contact your Authorized Service Dealer or
Distributor or go to www.Toro.com for a list of all approved
attachments and accessories.
14