Страница 1: ... right sides of the machine from the normal operating position 1 Setting Up the Motion Control Levers No Parts Required Procedure 1 Remove the upper bolt 3 8 x 1 inch and washer loosen the lower bolt 3 8 x 1 inch as shown in Figure 1 Raise the motion control levers 2 Align the holes in the motion control lever with the holes in the control arm shaft and install the bolt and washer removed previous...
Страница 2: ...s and raise the seat Figure 2 Move the control levers back to the center position neutral G006481 Figure 2 4 Verify the motion control levers are properly aligned Figure 3 Adjust as necessary Tighten all fasteners G006482 Figure 3 2 ...
Страница 3: ... proper inflation Refer to Checking the Tire Pressure in the Operator s Manual for the recommended inflation pressure Checking the Side Discharge Chute Remove the packing restraint holding the side discharge chute up and lower the chute into place Checking the Engine Oil Level Before you start the engine and use the machine check the oil level in the engine crankcase refer to Checking the Oil Leve...
Страница 4: ......