Toro TimeCutter, Инструкции по установке, Страница: 3 / 4

2
Connecting the Battery
No Parts Required
Procedure
1. Locate the battery and negative battery cable in the
left hand console of the machine.
2. Remove the fasteners on the negative battery post
and use them to secure the negative battery cable to
the negative battery post (Figure 4).
G005280
1 2 5 4 3
Figure 4
1. Wing nut 4. Negative battery post
2. Washer 5. Carriage bolt
3. Negative battery cable
3
Completing the Setup
Parts needed for this procedure:
1 Ignition Key
1 Hose coupling
1 Operator’s Manual
1 Engine Operator’s Manual
1 Operator Training Material
Procedure
Checking the Tire Pressure
Check the front and rear tires for proper inflation. Refer
to Checking the Tire Pressure in the
Operator’s Manual for
the recommended inflation pressure.
Checking the Side Discharge Chute
Remove the packing restraint holding the side discharge
chute up and lower the chute into place.
Checking the Engine Oil Level
Before you start the engine and use the machine, check
the oil level in the engine crankcase; refer to Checking
the Oil Level in the
Operator’s Manual .
Checking the Mower Adjustment
The mower deck was leveled at the factory. If the mower
is not cutting level, adjust the side-to-side level and the
front-to-rear blade slope. See the Operator’s Manual
for the proper procedure.
Review the Remaining Parts
Keep all the following items with the machine:
• Ignition Key
• Hose coupling
• Operator’s Manual
• Engine Operator’s Manual
• View the Operator training material.
3