Toro TimeCutter ZS 3200S, Руководство оператора

Страница: 39 / 56

Inspecting the Blades
Service Interval: Before each use or daily—Check the
cutting blades.
1. Inspect the cutting edges ( Figure 48 ).
Note:
If the edges are not sharp or have nicks, remove
and sharpen the blades; refer to Sharpening the Blades
(page 40) .
2. Inspect the blades, especially the curved area ( Figure
48 ).
Note:
If you notice any damage, wear, or a slot
forming in this area (items 3 and 4 in Figure 48 ),
immediately install a new blade.
Figure 48
1. Cutting edge 3. Wear/slot forming
2. Curved area 4. Damage
Checking for Bent Blades
Note:
The machine must be on a level surface for the
following procedure.
1. Raise the mower deck to the highest height-of-cut
position; also considered the 'transport' position.
2. While wearing thickly padded gloves, or other adequate
hand protection, slowly rotate the blade to be measure
into a position that allows effective measurement of the
distance between the cutting edge and the level surface
the machine is on (
Figure 49 ).
G009679
1
2
3
Figure 49
1. Deck 3. Blade
2. Spindle housing
3. Measure from the tip of the blade to the flat surface
(
Figure 50 ).
G009680
1
2
3
Figure 50
1. Blade (in position for measuring)
2. Level surface
3. Measured distance between the blade and the surface (A)
4. Rotate the same blade 180 degrees, so that the opposing
cutting edge is now in the same position (
Figure 51 ).
G009681
1
2
3
Figure 51
1. Blade (side previously measured)
2. Measurement (position used previously)
3. Opposing side of blade being moved into measurement
position
5. Measure from the tip of the blade to the flat surface
(
Figure 52 ).
Note:
The variance should be no more than 3 mm
(1/8 inch).
39