Toro TimeCutter Z530, Руководство оператора

Страница: 17 / 44

Important:
Make sure that the spacers
stay in place when loosening the knobs
to move the seat. Loss of the spacers can
result in damage to the seat.
2. Move the seat to the desired position and
tighten the knobs.
Figure 13
1. Adjustment knobs
Adjusting the Motion
Control Levers
The motion control levers can be adjusted higher
or lower for maximum operator comfort.
1. Remove the 2 bolts holding the control lever
to the control arm shaft (Figure 14).
2. Move the control lever to the next set of holes.
Secure the lever with the 2 bolts (Figure 14).
Figure 14
1. Control lever 3. Control arm shaft
2. Bolt
3. Repeat the adjustment for the opposite control
lever.
Pushing the Machine by
Hand
Important:
Always push the machine
by hand. Never tow the machine because
damage may occur.
To Push the Machine
1. Park the machine on a level surface and
disengage the blade control switch.
2. Move the motion control levers outward to
engage the parking brake, stop the engine,
remove the key, and wait for all moving parts
to stop before leaving the operating position.
3. Raise the seat to access the bypass levers
(Figure 15).
4. Move the two bypass levers forward and then
outward to lock them in place as shown in
Figure 15.
5. Move the motion control levers inward to
disengage the parking brake.
The machine is now able to be pushed by hand.
17