3
Setting Up the Motion-control
Levers
No Parts Required
Procedure
1.
Locate the motion-control levers attached, but folded
down on the machine.
2.
Remove the upper bolt (3/8 x 1 inch) and washer;
loosen the lower bolt (3/8 x 1 inch).
3.
Raise the motion control levers to the upright position.
4.
Align the holes in the motion-control lever with the
holes in the control-arm shaft, and install the bolt
and washer removed previously. Repeat this for both
controls levers.
Note:
Hand tighten all fasteners.
5.
Move the motion-control levers to the park position,
raise the seat, and move the control levers back to the
center position (neutral).
6.
Verify that the motion-control levers are properly
aligned.
Note:
Adjust as necessary. Tighten all fasteners.
4
Connecting the Seat-hold Bar
No Parts Required
Procedure
Note:
Use Figure 4 and Figure 5 to determine which
seat-hold bar is on your machine. Follow the appropriate
instructions.
1.
If your seat latch is as shown in Figure 4, locate the
seat-hold bar on the frame of the machine.
2.
Remove the fasteners.
3.
Install the seat-hold bar to the seat frame.
4.
Secure the bar with the washer and cotter pin removed
previously (Figure 4).
g027213
1
2
3
4
5
Figure 4
1.
Cotter pin
4.
Seat hold bar
2.
Washer
5.
Hole for pin, seat hold bar
3.
Seat
5.
If your seat-hold bar is as shown in Figure 5, ensure
the seat latch is above the welded tab the first time it is
put into the user position.
Note:
Ensure the seat latch works and prevents the
seat from rotating fully forward.
g027214
1
2
Figure 5
1.
Seat latch
2.
Welded tab
3
