Toro TimeCutter HD MyRide 60in, Руководство оператора

Страница: 15 / 32

5
2
4
G018361
1
3
Figure 16
Hood Installation
1. Hood 4. Pivot bracket with
keyed-pivot pin
2. Hood bracket with keyhole
slot 5. Hood installed
3. Hopper-support frame
3. Rotate the hood so that the keyhole slot is up, and align
the hood to the right of the keyed-pivot pins (
Figure
16 ).
4. Assemble the hood to the hopper frame by sliding the
keyhole brackets over the keyed pins (
Figure 16 ).
5. Rotate the hood down to secure the hood to the
hopper-support frame as shown in
Figure 16 .
Install the air-cleaner cover as follows:
Note:
Ensure that the primary air filter is fully seated by
pushing on its outer rim.
Important:
Do not press on the soft inside area of the
filter
1. Position the air-cleaner cover so that the breather valve
is located at approximately 5 o’clock (
Figure 17 ).
1 3
2
3
G018610
Figure 17
Air-Cleaner Cover
1. Air-cleaner cover 3. Air-cleaner latch
2. Breather valve
2. Secure the latches ( Figure 15 ).
Install the bag assemblies onto the hopper-support frame
as follows:
1. Raise the hood to expose the notched-bag brackets on
the hopper-support frame as shown in
Figure 18 .
15