Toro Tempus Air BS, Руководство пользователя, Страница: 8 / 60

Toro Tempus Air BS
8
Step 4
LoRa
TM
TEST CONNECTION
If the association of the modules is carried out before the final installation of the Tempus Air BS, this connection test can be used to validate the positioning of
the latter by going to temporarily install the Tempus Air BS in its intended location then by going to position a module in each of the valve box to verify good
communication with the Tempus Air BS.
The connection test can also allow you to verify at any time the correct operation of the LoRa
TM
radio between your module and the Tempus Air BS.
(Example: the product fell into the upside-down valve box and no longer communicates with the Tempus Air BS).
To test the LoRa
TM
connection, do the following:
1. Enter the Tempus Air
module in Bluetooth®
Then in the parameters
(small pencil at the top right)
3. Push the red button to test
the connection LoRa
T
M
4. The message indicate that the
LoRa
TM
connection between the
Tempus Air BS and the module is
reliable.
If the connection is not established, a "No connection established" message appears. Repeat this test several times to confirm that the connection cannot be made.
In this case, the distance between the Tempus Air BS and the Tempus Air module will need to be reduced.
LoRa
TM
STATUS CONNECTION
Preamble :
• The communication periodicity in LoRa
TM
mode :
The communication interval of the LoRa TM radio between the Tempus Air modules and Tempus Air BS is approximately 3 minutes (Battery full charged). You can see
the Tempus Air BS's power mode and its battery charge status in the table on the next page.
• Status of LoRa TM radio communication between the modules and the Tempus Air BS. These icons indicate when the Tempus Air BS was last connected to a
module via LoRa
TM
.
Last connection < 24 hours
Connection never done or very
long time without communication
with the gateway.
Last connection > 24 hours
Changes not transmitted
During the first installation it is necessary to charge the Tempus Air BS battery for 24 hours with 230VAC power before turning it ON.
2. Push on « Remote access »