Toro Super Recycler 20062, Руководство оператора

Страница: 11 / 20

Figure 29
2. Lift open the side discharge door (Figure 30).
Figure 30
3. Install the side discharge chute and close the door onto
the chute (Figure 31).
Figure 31
Removing the Side Discharge Chute
To remove the side discharge chute, reverse the steps above.
Important:
Lock the side discharge door after you
close it (Figure 32).
Figure 32
Operating Tips
General Mowing Tips
•
Clear the area of sticks, stones, wire, branches, and
other debris that the blade could hit.
•
Avoid striking solid objects with the blade. Never
deliberately mow over any object.
•
If the mower strikes an object or starts to vibrate,
immediately stop the engine, disconnect the wire from
the spark plug, and examine the mower for damage.
•
For best performance, install a new blade before the
cutting season begins.
•
Replace the blade when necessary with a Toro
replacement blade.
Cutting Grass
•
Cut only about a third of the grass blade at a time. Do
not cut below the 2-inch (51 mm) setting unless the
grass is sparse or it is late fall when grass growth begins
to slow down. Refer to Adjusting the Cutting Height.
•
When cutting grass over 6 inches (15 cm) tall, mow
at the highest cutting height setting and walk slower;
then mow again at a lower setting for the best lawn
appearance. If the grass is too long, the mower may
plug and cause the engine to stall.
• Mow only dry grass or leaves. Wet grass and leaves tend
to clump on the yard and can cause the mower to plug
or the engine to stall.
Wet grass or leaves can cause serious injury if
you slip and contact the blade. Mow only in dry
conditions.
•
Alternate the mowing direction. This helps disperse the
clippings over the lawn for even fertilization.
•
If the finished lawn appearance is unsatisfactory, try one
or more of the following:
– Replace the blade or have it sharpened.
– Walk at a slower pace while mowing.
– Raise the cutting height on your mower.
– Cut the grass more frequently.
– Overlap cutting swaths instead of cutting a full
swath with each pass.
– Set the cutting height on the front wheels one notch
lower than the rear wheels. For example, set the
front wheels at 2-1/4 inches (60 mm) and the rear
wheels at 2-3/4 inches (70 mm).
Cutting Leaves
•
After cutting the lawn, ensure that half of the lawn
shows through the cut leaf cover. You may need to
make more than one pass over the leaves.
•
If there are more than 5 inches (13 cm) of leaves on the
lawn, set the front cutting height one or two notches
higher than the rear cutting height.
•
Slow down your mowing speed if the mower does not
cut the leaves finely enough.
11