Toro snowmax 724 QXE, Руководство оператора

Страница: 13 / 20

Checking and Adjusting the
Skids
Service Interval: Yearly
Check the skids to ensure that the auger does not contact the
paved surface. Adjust the skids as needed to compensate for
wear (
Figure 17 ).
1. Loosen the skid bolts.
2. Slide a 5 mm (3/16 inch) board underneath the scraper.
Note:
Using a thinner board will result in a more
aggressive scraper. A thicker board will result in a less
aggressive scraper.
3. Lower the skids to the ground.
Note:
Ensure the skids are flat on the ground.
4. Tighten the skid bolts.
Figure 17
1. 5 mm (3/16 inch) board 2. Ground
Inspecting the Throwing
Edges
Service Interval: Yearly—Inspect the throwing edges and
have an Authorized Service Dealer
replace the throwing edges and scraper
if necessary.
Before each session, inspect the throwing edges for wear.
When a throwing edge has worn down to the wear indicator
hole, have an Authorized Service Dealer replace the throwing
edges (
Figure 18 ).
Figure 18
1. The wear indicator hole
is intact; you do not need
to replace the throwing
edges. 2. The wear indicator hole
is exposed; replace both
throwing edges.
Changing the Engine Oil
Service Interval: After the first 2 hours
Yearly
Run the engine a few minutes before changing the oil to warm
it. Warm oil flows better and carries more contaminants.
1. Move the machine to a level surface.
2. Place an oil drain pan under the oil-drain plug, remove
the oil-drain plug, and tip the machine backward and
drain the used oil in the oil-drain pan (
Figure 19 ).
13