Toro Reelmaster 7000-D, Инструкция по установке

Страница: 1 / 2

Form No. 3397-475 Rev A
Window Guard Kit
2015 and After Reelmaster ® 7000-D Traction Unit with Cab
Model No. 132-3295
Installation Instructions
WARNING
CALIFORNIA
Proposition 65 Warning
This product contains a chemical or chemicals known to the State of California to
cause cancer, birth defects, or reproductive harm.
Note:
Determine the left and right sides of the machine from the normal operating position.
Loose Parts
Use the chart below to verify that all parts have been shipped.
Description Qty. Use
Guard assembly 2 Install the guards.
Installing the Guards
1. Park the machine on level ground, lower the mower
decks, set the parking brake, stop the engine, and
remove the key.
2. On 1 side of the cab, loosen, but do not remove, the 3
flange nuts and the 3 bolts securing the bottom front
window to the frame of the cab (
Figure 1 ).
Figure 1
1. Flange nut 3. Bolts
2. Washer (3) 4. Shoulder bolt
3. While holding the glass in place, remove the 3 nuts, the
3 bolts, and the 3 washers.
Note:
Retain the nuts and bolts and discard the
washers.
4. While still holding the glass in place, align a guard
assembly over the glass (
Figure 2 ).
© 2015—The Toro® Company
8111 Lyndale Avenue South
Bloomington, MN 55420 Register at www.Toro.com. Original Instructions (EN)
Printed in the USA
All Rights Reserved
*3397-475* A