Toro reelmaster 6000-d series, Руководство оператора

Страница: 9 / 28

Figure 15
1. Lift chain 2. Snapper pin
9. Coat the spline of the reel motor with clean grease.
10. Oil the reel motor O-ring and install it onto the motor
flange.
11. Install the motor by rotating it clockwise so that the
motor flanges clear the cap screws (
Figure 16 ).
12. Rotate the motor counterclockwise until the flanges
encircle the cap screws and then tighten the cap screws.
Important:
Make sure that the reel motor hoses
are not twisted, kinked, or at risk of being pinched.
Figure 16
1. Reel motor 2. Cap screw
Note:
If a fixed cutting unit position is required,
insert the steering locking pin into the pivot knuckle
mounting hole (
Figure 14 ).
13. Hook the spring wire around the bottom of the steering
locking pin (
Figure 14 ).
9