Toro reelmaster 6000-d series, Руководство оператора

Страница: 8 / 28

Note:
Remove the counterweight ( Figure 12 ).
Figure 12
1. Counterweight
2. On the right end of the cutting unit, remove the plastic
plug from the bearing housing (
Figure 13 ).
3. Remove the 2 cap screws from the right side plate
(
Figure 13 ).
G003321
1
2
Figure 13
1. Plastic plug 2. Cap screw (2)
4. Install the counterweight to the right end of the cutting
unit with the 2 screws previously removed.
5. Loosely install the 2 reel motor mounting cap screws
to the left side plate of the cutting unit (
Figure 13 ).
7
Installing the Cutting Units
Parts needed for this procedure:
5/7 Large O-ring
2 Screw
Procedure
1. Insert a thrust washer onto the horizontal shaft of the
pivot knuckle as shown in
Figure 14 .
Figure 14
1. Carrier frame 4. Lynch pin
2. Pivot knuckle
5. Steering locking pin
3. Lift-arm steering plate
2. Insert the horizontal shaft of the pivot knuckle into the
mounting tube of the carrier frame (
Figure 14 ).
3. Secure pivot knuckle to carrier frame with a thrust
washer, a flat washer, and a flange-head cap screw
(
Figure 14 ).
4. Insert a thrust washer onto the vertical shaft of the
pivot knuckle (
Figure 14 ).
5. If removed, insert the vertical shaft of the pivot knuckle
into the lift-arm pivot hub (
Figure 14 ).
6. Guide the pivot knuckle in place between the 2 rubber
centering bumpers in the underside of the lift-arm
steering plate.
7. Insert the lynch pin into the cross hole on the
pivot-knuckle shaft (
Figure 14 ).
8. Secure the lift arm chain to the cutting unit chain
bracket (
Figure 15 ) with the snapper pin as follows:
•
On cutting unit numbers 1, 4, 5, 6, and 7, use only
6 of the chain links.
•
On cutting unit numbers 2 and 3, use all 7 of the
chain links.
8