Toro Reelmaster 5510 Series, Руководство по обслуживанию

Страница: 544 / 662

Checking the Reel Bearing Adjustment (continued)
4. Use a suitable torque wrench and spline insert tool (refer to (page ) ), measure
the rolling resistance of the cutting reel. The cutting reel rolling torque should
not exceed
1.1 N∙m (10 in-lb) .
5. If reel has end-play or if rolling torque is incorrect, perform the reel bearing
adjustment; refer to Adjusting the Reel Bearing (page 9–14) .
6. After checking or adjusting the reel bearings, adjust the cutting unit; refer to
the Cutting Unit Operator’s Manual .
7. Install the hydraulic reel motor to the cutting unit; refer to Installing the
Hydraulic Reel Motor (page 9–17) .
Adjusting the Reel Bearing
g214493
Figure 324
1. LH side plate 3. Bearing adjuster nut
2. Threaded insert 4. Set screw
1. Ensure that there is no contact between the bedknife and the reel.
2. Remove the cutting unit components on the LH side plate to get access
to the bearing adjuster nut. If the cutting unit is equipped with a rear roller
brush; refer to the
Rear Roller Brush – Optional (cutting units with painted
side plates) (page 9–51) . If the cutting unit is equipped with a groomer; refer
to the Groomer chapters in this manual.
3. Loosen the set screw that secures the bearing adjuster nut in the LH side
plate of the cutting unit.
IMPORTANT
Over tightening the reel bearing adjuster nut may damage the reel
bearings.
4. With the cutting unit and reel in a horizontal position, use a 1 3/8 inch socket
and torque wrench to overtighten the bearing adjuster nut to 4.5 to 5.1 N∙m
(40 to 45 in-lb) .
5. Loosen the bearing adjuster nut and then torque the bearing adjuster nut
to 1.7 to 1.9 N∙m (15 to 17 in-lb) .
Cutting Unit: Adjustments Page 9–14 Reelmaster ® 5410/5510/5610 Series
15216SL Rev C